What's new with this tower?
The flight controller upgrade from SP racing F3 to Omnibus F4.
EFM8BB21F16G MCU, pipelined 8-bit C8051 core with 50 MHz maximum operating frequency.
Dedicated high frequency driver, makes the start more smooth. ESC maximum speed is limited to 500k eRPM.
Two layers tower structure between 4in1 ESC and FC using quick pin connection. Dual ways signal transmission makes the flight more stable
Exposed pads for Battery and Motor wires, fast welding without additional disassembly, makes the installation faster and more convenient.
Omnibus F4 flight controller, supports PPM,SBUS,SPEKTRUM 1024/2048 etc. remote control / receiving mode.
FC integrated OSD, also integrated 3.3V,5V,12V for VTX, camera, buzzer, LED and other peripheral devices ; provided several silicone cables for connectors on FC ,and will give you an unprecedented experience for installation;
Built-in current meter, OSD directly display the real-time current without any additional connection;
BLHeli-S firmware. It designed for superior performance in multirotors, and uses hardware generated motor pwm for smooth throttle response and silent operation.
The code supports regular 1-2ms pulse width input, as well as Oneshot125 , Oneshot42 and Multishot .
Supports Dshot150, Dshot300 and Dshot600.Dshot is digital signal, anti-interference ability is stronger, and do not need throttle calibration.
Support Voltage: 2-4S Lipo
Con. Current: 30A
Burst Current: 40A
F.C Volt: 3.3V/5V/12V
MCU of F4: stm32f405
Gyro of F4: MPU-6000 SPI
F4 Firmware: Betaflight_OMNIBUSF4SD
Flycolor Raptor BHeli-S 30A 4in1 ESC x 1
Omnibus F4 Flight Controller x 1
Connection Wires x 1