Pentium-60A-OPTO & Pentium-60A are products in "PENTIUM" series. "PENTIUM" series has the full range of ESCs from 6A to 100A.
1.1 Output: Continues 60A, Burst 80A up to 10 Secs.
1.2 Input Voltage: 5.6V --- 26.0V ( Lithium : 2 ¨C 6s or NiMH/NiCd 5 -18 Cells)
1.3 BEC (Battery Elimination Circuit) Output£º
¡ñPentium-60A£º (linear mode BEC)£º3A
¡ñPentium-60A-OPTO£º None. Pentium-60A-OPTO is often used with an UBEC
1.4 Max Speed: 210,000rpm for 2 Poles BLM, 70,000rpm for 6 poles BLM, 35,000rpm for 12 poles BLM. (BLM: BrushLess Motor)
1.7 Packaging include:
3 sets of gold plated motor connectors and heat-shrink tubings (Remark: motor connectors and heat-shrink tubings need to be purchased additionally)
2.1 Safety Arming Feature: Regardless the Throttle Stick position, the motor will not spin after battery connected. This will prevent any injury happened.
2.2 Throttle Calibration: Throttle range can be configured to provide best throttling linearity, fully compatible with all market available transmitters.
2.3 Programmable Items:
¡ñBrake Settings£ºbrake enabled / brake disabled, default is brake disabled
¡ñBattery Type£ºLi-xx(Li-ion or Li-poly) / Ni-xx(NiMh or Nicd)£¬default is Li-xx.
¡ñLow Voltage Protection Mode(Cutoff Mode) £ºpower reducing / power cutoff, default is power reducing.
¡ñLow Voltage Protection Threshold(Cutoff Threshold) £ºlow / medium / high, default is medium cutoff voltage.
1) For Li-xx battery£¬number of battery cells are judged automatically£¬low / medium / high cutoff voltage for each cell are: 2.6V/2.85V/3.1V. For example: 3 Cells Li-Poly, when medium cutoff voltage is set, the cutoff voltage is: 2.85*3=8.55V.
2) For Ni-xx battery, low / medium / high cutoff voltages are 0%(ie. never cut off )/45%/60% of the startup voltage. For example: a 10 cells NiMH battery pack, fully charged voltage is 1.44*10=14.4V, when medium cutoff voltage is set, the cutoff voltage is : 14.4*45%=6.5V.
¡ñStartup mode: normal / soft / super-soft, default is normal startup.
¡ñTiming: low / medium / high, default is medium timing. In normal cases, low timing can be used for most motors. But for high efficiency, we recommend the Low timing for 2 poles motor and Medium timing for 6 poles and above. For higher speed, High timing could be used.
2.4 Full Protection Features: Low-voltage cutoff protection / over-heat protection / throttle signal lost protection.
3.1 Military Standard Capacitor with extremely low resistance used on voltage input section, this will increase the ability of prevention of unwanted RF Noise/ Interference during flying.
3.2 Seperate PCB for control circuit and MOSFET circuit: adiabatic air gap between control circuit PCB and MOSFET circuit PCB reduces the heat exchange form MOSFET to control circuit, so the ESC works more reliable.
3.3 Extreme low resistance, super current endurance.
3.4 Microprocessor and BEC use separate voltage regulator IC, with good anti-jamming capability.
3.5 Compatible with Hobbywing's Program Card .
3.6 Own complete intellectual property rights.